I am posting this for a friend, give me a PM if interested or call him your self .Pictured to follow!
Five color let down on a black base gelcoat, chocolate brown to tan with an orange outline.
Custom interior to include gunwale seats over tunnels - no tears or fading.
Full instrumentation. Nordskog speedo, trim, transom jack, water temp, water pressure, digital tachometer, and fuel.
Bottom blueprinted and speed-coated - may need new speed-coat.
Foot throttle, and trim/tilt, hydraulic transom jack on floor. Once you shift into gear you do not have to remove your hands from the steering wheel.
110 GPH fuel pump on separate switch.
2 – 20 gallon aluminum gunwale fuel tanks with SS braided line to fuel pump.
Fuel pickups opened up to ½”
Aluminum billet manual fuel switch valve.
Custom made aluminum and Stainless steel ski pole.
Navigation lights
Three bilge pumps. One in each sponson and one in the center pod.
Opposing entry rack and pinion steering to counteract torque.
6” Eliminator anodized setback bracket.
Custom made aluminum after planes over tunnels with stainless steel turnbuckles.
Boat has very few scratches from use. I can only find one stress crack on one of the sponsons. If you know anything about Eliminator, this will not surprise you.
Boat has run 102.369 mph with an old Cross Flow Evinrude in a sanctioned SLDBA race. I ran in the 13.000 to 13.750 bracket.
Boat is in excellent condition and has been stored inside except when on the water.
1990 Johnson 225 Outboard
This is a fresh outboard with 3 hours break-in time only, on complete repower.
Powerhead was new from Southwest Marine to include;
New pistons, rings, seals, bearings, and gaskets.
Reed banks have been cleaned, blueprinted, and have Boyensen single stage reeds.
Engine has been deburred in intake and all water passages.
Six brand new carburetors, with new bodies, and new internal kits.
New powerpack.
6 new coils.
6 new spark plug wires.
New plugs.
Tested and tuned by professional boat shop.
EXTRA PARTS THAT GO WITH BOAT
Powerhead with crank and end caps.
Set of heads that have been milled .010” for higher compression [never used]
Enough parts to build six additional carburetors.
7 spare coils.
Spare intake manifold and reed cages with stainless steel reeds.
Spare lower unit that has a Land and Sea low water pickup nosecone, with new shift dogs.
4 rods with used pistons. One new 0.030” over piston.
Box of assorted nuts, bolts, and parts for powerhead.
Other assorted parts, linkages, shift rod, air box, wiring harnesses, and such.
TRAILER
Trailer is not the prettiest thing on the market but gets the job done.
It is a 1976 Roadrunner tandem axle trailer converted from a vee bottom trailer to a tunnel hull trailer. Everything has been welded, sandblasted, and painted brown. Tires have good tread. The trailer has served me well since 1976.
I am asking $10,000.00 for the entire package. I will consider delivering the boat within 500 miles of St. Louis, Missouri for $0.32 a mile.
Joel West
618.781.7064